With the development of the times, the electronic industry develops on the basis of the development and application of Electronic Science and technology. Electronic industry is one of the pillar industries of the national economy, and it is a new industry of science and technology development. Cable protection is particularly important. Using Jinan cable tray can avoid the damage of cable life caused by dust and corrosion. The following is how to repair and protect the cable tray to prolong its service life and reduce the cost of maintenance.

濟南電纜橋架

Jinan cable bridge

一、電纜橋架的修 復工作

1、 Repair of cable tray

1.銹跡處理

1. Rust treatment

通常濟南電纜橋架采用氯磺化底漆二道進行兩部分除銹，表面除銹處理質量直接影響防腐工程的壽命，現場除銹通常是砂輪機或者人工除銹，在表面處理之后，在4小時內涂上底漆。如果處理不當發現有新銹，必 需進行重新處理。

Generally, Jinan cable bridge adopts two layers of chlorosulfonated primer for two-part derusting. The quality of surface derusting treatment directly affects the service life of anti-corrosion engineering. The on-site derusting is usually done by grinding machine or manual derusting. After the surface treatment, the primer is applied within 4 hours. If new rust is found after improper treatment, it must be treated again.

2.涂層處理

2. Coating treatment

涂層工藝分為刷涂、滾涂。刷涂或者滾涂時每層應從橫交錯反復進行涂，直到均勻?yàn)橹?，不能出現漏涂。

The coating process is divided into brush coating and roll coating. When brushing or rolling coating, each layer shall be applied repeatedly and crosswise until it is uniform, and there shall be no missing coating.

3.施工環境要求

3. Construction environment requirements

環境需要通風良好，溫度在13℃-30℃，不得低于5℃，相對濕度保持在80%以內。不宜在強烈日光下施工。遇到雨、霧、強風氣候不得在室外進行施工。

The environment needs to be well ventilated, the temperature should be between 13 ℃ and 30 ℃, not lower than 5 ℃, and the relative humidity should be kept within 80%. It is not suitable for construction in strong sunlight. In case of rain, fog and strong wind, construction shall not be carried out outdoors.

二、電纜橋架的維護

2、 Maintenance of cable tray

1.避免擺放在高溫潮濕地方。

1. Avoid placing in hot and humid places.

2.避免與腐蝕性液體接觸。

2. Avoid contact with corrosive liquid.

3.可用電纜橋架專用的保養蠟進行保養。

3. Special maintenance wax for cable tray can be used for maintenance.

4.定期清理濟南電纜橋架表面的灰塵與銹跡。

4. Regularly clean the dust and rust on the surface of Jinan cable tray.

濟南電纜橋架

Jinan cable bridge

以上就是濟南電纜橋架的修復與維護工作，電纜橋架也可以適用于電廠、化工、石化等領域，因?yàn)橛心透g的電纜橋架，特別適用于具有高腐蝕環境的場所。

The above is the repair and maintenance work of Jinan cable tray. Cable tray can also be used in power plant, chemical industry, petrochemical and other fields, because there are corrosion-resistant cable tray, especially suitable for places with high corrosion environment.